User's Manual
ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 55 of 129
6.6.1.2 Optional base station settings
ITC2100 -
Version I
ITC2100 -
Version II
Alarm inputs (local alarming)
A POCSAG message is transmitted via the input (e.g.
a POCSAG message can be transmitted from a fire
detector connected to input 1)
1x
(channel 1)
4x
(channel 1 .. 4)
Sync card SC,
D-Sub9 connector
Channel 1:
Pin 1: high (+)
Pin 4: low (-)
I/O card
Channel 2:
-
Pin 2: Opto IN 0
Pin 3: Opto GND 0
Channel 3:
-
Pin 6: Opto IN 2
Pin 7: Opto GND 2
Channel 4:
-
Pin 8: Opto IN 3
Pin 9: Opto GND 3
Inputs for remote polling (digital inputs)
The status of the inputs (on, off) can be polled from a
remote Network alarm controller (e.g. the status of an
active lightning protector for the antenna output can be
polled)
1x
(Channel 5)
3x
(Channel 5, 6, 7)
Sync card SC,
D-Sub9 connector
Channel 5:
Pin 7: high (+)
Pin 9: low (-)
I/O card
Channel 6:
-
Pin 11: Opto IN 4
Pin 12: Opto GND 4
Channel 7:
-
Pin 4: Opto IN 1
Pin 5: Opto GND 1
Relay outputs (digital outputs)
A siren can be connected to the output (channel 1 to
3). This can be switched from a remote location (using
a special RIC address).
The remaining outputs can be enabled or disabled
locally from the base station. (e.g. to open /close
doors). For the future it would possible to switch these
outputs remotely from the network alarm controller.
1x
(Channel 1)
7x
(Channel 1 .. 7)
A siren can be
switched via chan-
nels 1 to 3
Sync card SC,
D-Sub9 connector
Channel 1:
Pin 6: high (+), OC
Pin 8: low (-), GND
I/O card
Channel 2:
-
Pin 1+2: Relais 0
Channel 3:
-
Pin 3+4: Relais 1
Channel 4:
-
Pin 5+6: Relais 2
Channel 5:
-
Pin 7+8: Relais 3
Channel 6:
-
Pin 9+10: Relais 4
Channel 7:
-
Pin 11+12: Relais 5
Channel 8:
-
Pin 13+14: Relais 6
Table 1: Overview of the available in and inputs and outputs
The difference between version I ("value I") and version II ("value II" i.e. ITC2100 with op-
tional I/O card) is in the number of digital inputs and outputs. An ITC2100 can be upgraded
by inserting the I/O card.