User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 32 of 129
6 Service Web-Interface of the ITC2100-NA
The ITC2100-NA programming is carried out using a web-interface, which can be accessed
by any standard internet browser, such as Firefox or Internet Explorer. Connect a PC or
Laptop using a crossover Ethernet cable with RJ45 plug (LAN) to the ITC's Ethernet con-
nection. Then enter the repeater IP address in the browser window of the PC or Laptop.
The browser then displays the access page of the programming interface.
6.1 General Operating Information
The language German is set by default. The user interface can be switched to English (see
chapter 6.9.2.1).
Click on the button Apply to enter and update the setting that have been
made.
Click on the button Refresh to request the current system operating mode
and it will be displayed. Otherwise the status is periodically updated.
Click the button Back to return to the previous menu.
6.2 Installation and Setting Up the Laptop/PC
6.2.1 Hardware
The computer must comply with the requirements below to permit full configuration.
 Network card (10Base-T or 100Base-T)
 Crossover Ethernet cable with RJ45 plug
6.2.2 Software
No special software is required for configuration. Only a conventional Internet browser (e.g.
Firefox 3 / Internet Explorer 6 / Internet Explorer 7
5
) is required.
6.2.3 Setting Up the Network Card
The two IP addresses must be in the same segment and on the same subnet mask in order
to ensure communication between laptop/PC and ITC. As an example, in Windows XP
these settings must be made in Control Panel with the Network program under Local Area
Connection.
Select and open the item Internet Protocol (TCP/IP) and press the button Properties.
5
Swissphone recommends to use Mozilla Firefox 3, Microsoft Internet Explorer 6 or 7. Dif-
ferent browser should work as well, but were not tested by Swissphone so far.