User's Manual

ITC2100-NA Operation and Service Manual Version 1.0

Page 29 of 129

5.15 Connection of the I/O Card to the ITC

The I/O card can be inserted in the free slot on the right next to the sync card or S-Com

card.

1. Switch the ITC off and disconnect the battery.

2. Unscrew and remove the cover plate next to the sync card or the wide cover plate next

to the S-com card (if used).

3. Unscrew the Sync card and pull it out by about 10 cm.

4. Connect the Sync card to the I/O using the flat cable.

Fig. 5-11: Connection of the I/O to the ITC2100-NA

5. Carefully insert both cards (possibly remove the cover plate on the right to make inser-

tion of the cards easier).

6. If the the wide cover plate was removed to install the S-com card, fit the narrow cover

plate (left over when the S-com card was fitted).

7. Reconnect the mains and battery and switch the ITC on.

8. Check that the green LED lights.

The connector pin assignments for the I/O card are listed in chapter 7.7.