User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 24 of 129
4. When two antenna connections are used set the jumpers to position 1 (see illustration
above)
5. Refit back panel.
6. Reconnect mains cable, reconnect battery and restart operation.
5.12.2 ITC Version with Slide Switch for Antenna Setting
1. Switch the ITC off and disconnect the battery.
2. When two antenna connections are used set the slide switch to position 1 (se illustra-
tion below).
Fig. 5-6: Position of slide switch for one or two active antenna connections
3. When two antenna connections are used, remove the blue protection cap.
4. Switch the unit back on.
Position 1: Two antennas
Antenna switch is in operation (Rx/Tx-
switchover active, i.e both antenna
connections are active)
Position 2: One antenna
(Standard setting)
Antenna switch is not in operation)
(RF output/input set to lower antenna
connection, upper antenna connection
"Rx" has no function)