User's Manual

ITC2100-NA Operation and Service Manual Version 1.0

Page 22 of 129

Fig. 5-2: Connecting the battery to the ITC2100-NA

Operating mode:

ITC-power consumption at battery connections (DC):

Standby (only Rx)

Tx 1W

24W

Tx 5W

37W

Tx 12W

50W

Tx 25W

Tx 40W

Tx 50W

75W

5.11 Power Supply to External Devices

External units can be supplied from the ITC power facilities. Connect the device to the ter-

minals marked with the inscription 13.5/1A max. on the back panel of the ITC2100-NA. The

cross-section of the connecting cables used must be at least 1.5 mm2. The external unit

can be supplied with a maximum of 13.5V / 1.5A.

Fig. 5-3: Connecting to external device for power supply

NOTE: When an external unit is supplied from the ITC power facilities, during power failure

the battery has an additional load. This will mean that the supply time from the battery will

be correspondingly shorter.

Plus pole (+)

Minus pole (-)