User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 13 of 129
4.1.2 Back side
The back side of the ITC2100-NA consists of the following connections:
1) Slide switch
1
for usage of one or two antenna connections
2) Coax N-type, 50 ohm, for combined transmitting (Tx) and receiving (Rx) antenna in
case of single antenna use mode (standard) or for transmitting (Tx) antenna only in
case of dual antenna use mode
3) Coax N-type, 50 ohm, for receiving (Rx) antenna in case of dual antenna use mode
4) Connection (screw connector) for powering external devices with 13.5V/1Amax
5) Battery connection Pb12V / 12Ah (screw connector)
6) Battery earthing
7) Mains 230V
4.2 Technical Data
Type:
ITC2100-NA
Dimensions (WxHxD):
483mm (19" rack) x 134mm (3U) x 315mm
Weight:
8.5 kg
Protection class:
IP 20
Operating temperature range:
-25 to +55°C
Mains supply:
90-264VAC/ 47-63Hz
Mains fuse:
T4 A / 250V
Emergency power supply:
External battery 12V
Battery fuse:
T12.5A/ 250V
Battery operation:
>4h at 25W transmit power and 25% duty cycle (with
12Ah battery)
Power consumption:
max.200W
Frequency band:
144-174MHz (different bands available)
Tx output power:
1-50W
Baud rates:
512 / 1200 / 2400 bps
Channel spacing:
12.5kHz
Compliance with EU regulati-
ons:
ETS 300113, ETS 300086, EN 60950, EN 50081-2, EN
50082-2, EN 61000-3-2/3
1
At ITC2100 models without slide switch the setting will be done via internal jumper