User's Manual

ITC2100-NA Operation and Service Manual Version 1.0

Page 124 of 129

8.6 Replacing the RC or RC09 card

Important: If the RC card is inserted in the ITC2100-NA, at least the hardware index D and

the FPGA version V0.8 are needed (see following figure).

Fig. 8-7 Compatibility of the RC card

8.6.1 Procedure

1) Shut down the ITC2100

2) Switch off the power supply (mains switch to position "0")

3) Disconnect the mains cable

4) Remove the "old" RC or RC09 card

 Release the 2 screws on the front panel and pull the card out of its slot

 Disconnect the cable from the RC or RC09 card

5) Insert the new RC or RC09 card

 Connect the cable to the correct connector on the RC or RC09 card (see figure be-

low).