User's Manual

ITC2100-NA Operation and Service Manual Version 1.0

Page 120 of 129

11) Enter the RSSI values of the new Transceiver Module in the Service web interface

 Enter the RSSI voltage values (ADC) in the configuration page in link "RSSI calibra-

tion" in section "System - Input RSSI" into the fields "RSSI low:" and "RSSI high:".

The values will be stored after clicking the button "Apply".

Fig. 8-2: Entering the RSSI voltage values for the new transceiver module

 Enter sending and receiving delay values in “configuration” in the “RxTx delay” link.

Fig 8-3: Enter the Rx/Tx delay values of the new transceiver module