User's Manual

ITC2100-NA Operation and Service Manual Version 1.0
© SWISSPHONE Wireless AG
Page 101 of 129
Transmitter data (Tx)
Tx output power:
1-50 W (UHF 40W), configurable in 1W-steps
Intermodulation attenuation:
> 40dB
Adjacent channel power:
< -70dB
Spurious emissions:
< 250nW (30MHz to 1GHz)
Receiver data (Rx)
Sensitivity:
<-110dBm at 12dB SINAD
Co-channel rejection:
> - 8dB
Adjacent channel selectivity:
> 70dB (at 20kHz channel spacing)
Spurious response rejection:
> 70dB
Blocking:
> 90dBµV (±1MHz to ±10MHz)
Spurious radiations:
< 2nW (30MHz to 1GHz)
Intermodulation response rejec-
tion:
> 70dB
The ITC features an antenna switch integrated in the receiver so that only one antenna
needs to be installed for reception and transmission. The receiver is automatically switched
off when the transmitter is booted up.
7.2 Power Supply Module PS200W
The power supply module is responsible for powering the entire base station ITC2100-NA.
The power supply module has the following technical data:
Input voltage:
90-264VAC / 47-63Hz
Power consumption:
Max. 200W
Max. output voltages/ currents:
13.8V / 8A and 5V / 5A
Efficiency:
80%, 10-15A typical charge
Battery low level protection:
Yes
Battery fuse type:
250V / 12.5AT
Mains fuse type:
250V / 4AT
Table 1: Technical data of the power supply module "PS 200W"