User Manual

I.SITE III User Manual
© SWISSPHONE Wireless AG Version 1.1 Page 14/20
5 Technical Data
Transmission unit (TX)
Frequency bands VHF4m / VHF2m /
UHF
66-88MHz / 136-174MHz / 400-470MHz / 450-530MHz
Transmitting power Adjustable ex works for: 1 to 25 W
Channel separation 12.5/20/25kHz
POCSAG Transmission rate 512, 1200, 2400 baud
Antenna port N-Type (female) 50Ω/port for external antenna
Duty cycle 33% at 25W (@ 131°F)
Interface
LAN 1x RJ45 (100 Mbps)
Call dog Proprietary call logs (available on request)
Control PC software or through third-party providers
Fault status reports
FS01 Unstable transmitting frequency (PLL Unlocked)
FS02
Fault in transmission unit TX (High FWD/low REV power or TX
excess temperature)
FS03 No operating voltage present (AC Power Fail)
FS04 (optional)
Operating voltage of backup battery below threshold value
(ACCU Low)
FS05 Incorrect transmitter keying (TX Not Allowed)
General
Backup battery (optional)
12 V / 2,3 Ah
charging port + battery low display + deep discharge
protection
Input contacts (optional)
Three contact inputs (E1, E2, E3 (open/close)) for triggering
messages (edge triggered, potential-free 5 - 15 V, debounced
to 100 ms)
Service contact (optional)
One door contact (open/close) for triggering messages during
servicing
Operating temperature range -4 °F to +131 °F // -20 °C to +55 °C
Input voltage (AC) 90-264VAC
Power consumption (max. 230 V) 5 W (stand-by), 75 W (sending at max. 25 W)
Protection class IP65
Dimensions (H x W x D) 15.8 x 8.3 x 4.7 inches // 400 x 210 x 120 mm
Weight 264.75 oz. // 7.5 kg (without optional backup battery)
Conformity
Data transmission ETS 300 279, ETSI 300 113
Electromagnetic compatibility EN 301489-05, EN55022
Security EN 60950