Operating Manual
Table Of Contents
- Introduction
- Putting into operation
- The complete LCD Displays
- Quattrino voice, memo
- Quattrino tone,eco
- Acoustic ON
- Mini-beep
- Acoustic OFF
- Monitor (Not for Quattrino tone, eco)
- Volume (Not for Quattrino tone, eco)
- Field strength alarm (Not for Quattrino tone, eco)
- Address display (Not for Quattrino tone, eco)
- Switching ON and OFF of the activated addresses (Not for Quattrino tone, eco)
- Message (Not for Quattrino tone, eco)
- Battery status indicator
- Battery / accumulator recognition
- New message
- Call retrieving (Pager with the voice memory)
- Call signalling
- Alarm timer (Not for Quattrino tone, eco)
- Acknowledgement / deletion
- General
copy rights by Operating Manual RE429NT+ / Opmanual429NT+.doc page 9/9
Swissphone Telecom
Roosstrasse 53 CH-8832 Wollerau PMA/D000120 edition 1 / 3. February 2003
After 60 minutes it appears only hours and sign for hours "h"
Total running time is 12 hours and then the alarm timer will disappear. Reset of the
alarm timer will be done with the execution button to quit the new message.
3.18 Acknowledgement / deletion
Briefly press the key (2), and the address arrow of the last message received will
begin blinking for about 3 seconds. Simultaneously, the LED in the upper left corner
will indicate the corresponding address pattern and the address appears in the
display. To delete the alert, press key (2) while the address arrow is blinking. The
alert will be deleted. The last received and already deleted alert remains stored in the
background, the address arrow and the address display can still be called up with
key (2), until you switch off the unit.
4 General
4.1 Battery operational life
75 - 120 hours depending on the operational mode programmed and the battery
used.
4.2 Week battery
A low battery / accumulator is recognisable by the empty battery symbol, and should
be replaced / re-charged as soon as possible.
Note: Please use the batteries recommended by the supplier only.
4.3 Illumination
A background illumination for the LCD, which is switched on with every key switch,
enables you to read the operational status of your unit in the dark.
For the connection of various additional units, e.g., output to a PC, printer, or for
battery charging.
4.4 Accessories
a) LG300/429 intelligent charging unit
b) LGA300/429 intelligent charging unit with aerial connection
c) LGRA300/429 intelligent charging unit with aerial connection and relay output
d) PGM300/425 Programming unit
4.5 Customer service
With this unit, you have purchased a high-quality product. If there should be a
problem in its operation, despite following these instructions, please return it to us in
the original packaging.