Operating Manual

copy rights by Operating Manual RE429NT+ / Opmanual429NT+.doc page 7/9
Swissphone Telecom
Roosstrasse 53 CH-8832 Wollerau PMA/D000120 edition 1 / 3. February 2003
the same way. After confirmation (1), the field strength symbol remains visible for
about 8 seconds, and then disappears if the field strength is sufficient.
3.9 Address display (Not for Quattrino tone, eco)
This 3 seven segment character serves as an address display. This free
programmable character can be assigned to the max. 12 addresses of the pager.
They will appear during the alerting of the proper address, during retrieving of the
proper call and during switching ON and OFF of the proper address.
3.10 Switching ON and OFF of the activated addresses (Not for Quattrino tone,
eco)
After the selection of the menu "Adr" it starts to blink. Now You will display the first
activated address by pushing the execute button. Ist sign (number, character ie)
appear in the display. Simultaneously it will appear the sign ON or OFF depending of
the current status (switched ON or OFF) of the address. Both "Adr" and the status
(ON or OFF) are simultaneously blinking. Now You can during the blinking change
the status with the execute push button which has a toggle function. With select
button You can continue to the next address. In the case that after the selection of
the "Adr" the signs ON and OFF does not appear in the display means that this
address is not set by programming to be switchable.
3.11 Message (Not for Quattrino tone, eco)
After the selection this symbols with the select button You can cause retrieving of all
current stored voice messages. (Possible only when pager has a speach memory).
3.12 Battery status indicator
100%
-
80%
80%
-
33%
33%
-
13%
13
%
-
0
%
With the operation switched on, the battery symbol is permanently visible in the
display, and shows the energy level at all times. If the energy source is completely
used up, the empty battery symbol blinks continuously. If the acoustics are switched
on, a regular beep tone is heard simultaneously. An operational time of 3 - 5 hours is
still available.
3.13 Battery / accumulator recognition
After a new energy source has been installed, the pager always knows whether this
is an accumulator or a dry battery. The switch-on procedure with self-test is only
possible if the battery or accumulator voltage is greater than 1.24 V. The information
as to whether a battery or accumulator has been loaded is then stored in the pager.
For accumulator operation, only the accumulator symbol appears in the LCD display.
If a battery is recognised, the text "BATTERY" appears next to the accumulator
symbol.