Operating Manual

copy rights by Operating Manual RE429NT+ / Opmanual429NT+.doc page 6/9
Swissphone Telecom
Roosstrasse 53 CH-8832 Wollerau PMA/D000120 edition 1 / 3. February 2003
3.3 Acoustic ON
Incoming calls will be signalled simultaneously with a call signal and a vibration. In
addition, the light display blinks in the upper left corner. Following this signalisation,
you will hear the spoken announcement via the loudspeaker.
3.4 Mini-beep
Incoming calls are indicated by the vibrator, and then with short beep tones. The LED
in the upper left corner also blinks. Finally, following this signalisation, you will hear
the spoken announcement.
3.5 Acoustic OFF
Incoming calls are signalled only by the vibrator. There is no acoustic alarm, and no
spoken announcement is heard.
3.6 Monitor (Not for Quattrino tone, eco)
In this operational mode, you can hear everything that is spoken over the set radio
channel. Calls addressed to you will be signalled "acoustically". If you wish to switch
off the continuous monitoring / listening operation, select one of the acoustic symbols
with key (1), and confirm this with key (2).
Notice to the point 3.1 until 3.4
Pager with the voice memory will record the spoken message than when with the
proper programming voice memory has been assigned to the proper address and
alarm type has been set to "Voice" or "Tone and Voice" status. In monitor mode
spoken message will be only recorded when proper address has been activated.
Voice memory can be in the programming assigned to the address fix or dynamically
and recording time can be set to 4x15, 3x20, 2x30 or 1x 60 sec.
3.7 Volume (Not for Quattrino tone, eco)
The announcement volume can be adjusted to 4 levels. (The volume of the call
signal, however, is unaffected). With key (1), select the volume symbol. Using key
(2), you can now select the desired level 1, 2, 3 or 4, which you can then
acknowledge with key (1). Level 1 is the quietest level, and level 4 the loudest. Level
3 corresponds to the nominal volume.
3.8 Field strength alarm (Not for Quattrino tone, eco)
Functional in radio networks with cyclical transmission sensing only.
This symbol appears as soon as you are no longer within the reception range. In
addition, a short term, acoustic beep signal sounds at regular intervals (depending
upon the acoustic setting, this could possibly only be a vibration signal).
You have the possibility of switching the field strength alarm off. Select the menu
symbol Field Strength using key (1). The symbol starts to blink. Now acknowledge
the Field Strength Alarm OFF by pressing key (2). The field strength symbol is no
longer visible. By incorrect reception, the field strength alarm will only be indicated
optically in the display. The acoustic field strength alarm can be switched on again in