Operating Manual

copy rights by Operating Manual RE429NT+ / Opmanual429NT+.doc page 4/9
Swissphone Telecom
Roosstrasse 53 CH-8832 Wollerau PMA/D000120 edition 1 / 3. February 2003
2.4 Switching off
This takes place by simultaneously pressing the keys SELECT(1) and EXECUTE(2)
for about 4 seconds. The frame of the battery symbol in the display blinks, and finally
the symbol disappears from the display, and the pager is switched off.
2.5 Switching on
If the unit is switched off, you can switch on the pager operation by simultaneously
pressing both operating keys SELECT(1) and EXECUTE(2).
Select (1) Keys Execute (2)
As a rule, a self-test takes place every time the unit is switched on, and briefly
displays the following check pattern.
1. Display of the programmed operational functions by symbols in the display and
sequential display of enabled addresses.
2. Control beeps
3. The LEDs light up
4. Short-term vibration
2.6 Selecting the operating status
The operation of the unit is very simple and ergonomic, and is designed for a high
level of operational security. The keys are located in the upper left and right corners
of the unit. The left-hand key (1) is SELECT, and the right-hand key (2) is EXECUTE.
With the left-hand key (1), you can select the desired operational symbol. The symbol
begins to blink. Using the right-hand key, the desired operational function can be
acknowledged, and the symbol ceases to blink in the display. The sequence takes
place depending upon how the symbol selection has been defined in the
programming. Only those symbols will be sequentially displayed which have been
enabled in the programming.