Operating Manual

copy rights by Operating Manual RE429NT+ / Opmanual429NT+.doc UHF page 8/9
Swissphone Telecom
Roosstrasse 53 CH-8832 Wollerau PMA/D000123 edition 1 / 05.11.2001
Note:
If the newly-inserted energy source (battery or accumulator) is only slightly charged,
the pager is not able to recognise at first whether it is a battery or an accumulator.
For this reason, it is first assumed that the inserted energy source is an accumulator,
and the charging current is switched on. Immediately afterwards, the voltage of the
energy source is measured and monitored. With a supply voltage of 1.24 V, the
switch-on test takes place, and the pager recognises either a battery or an
accumulator. The pager then stores this information. If an accumulator has been
inserted, the re-charging continues, and if a battery, the re-charging is immediately
stopped.
3.14 New message
Depending on the operational mode, incoming calls will be signalled via the
loudspeaker and the vibrator together. In addition to the complete alerting, you can
listen directly to the incoming spoken announcement, after which the LED light
display in the upper left corner blinks. 3 seven segment character (Not for Quattrino
tone, eco) and the address arrow shows you at a glance which memory address has
been seized. If seized addresses or calls are not acknowledged, a reminder call
occurs in the preprogrammed time slots. This can take place acoustically and
optically. For a "Tone only" message, the same alarm pattern takes place, and only
the address arrow appears at the corresponding "Memory Address".
3.15 Call retrieving (Pager with the voice memory)
After pushing the Execute key (2) voice retrieving procedure will be started. It
appears optical signalling of the proper address and spoken message will be
retrieved from the voice memory. Are there more calls (2) recorded retrieving will
continue without touching any other key.
3.16 Call signalling
Each of the eight call addresses can have a characteristic signalling pattern allocated
to it. You can determine the pattern yourself through the programming, and it can last
up to a maximum of 5 seconds.
3.17 Alarm timer (Not for Quattrino tone, eco)
Alarm timer can be activated by programming software. If activates than it appears in
the display elapsed time since last alert. This time display has a format miutes and
sconds (blinking) up to 9 minutes and 59 seconds
After 10 minutes it changes format to minutes and minutes sign