Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 503272_14.04.2021
HDbaseT HDMI2.0 Extender 100m
Technical specications
Resolutions input up to 2160p60
output up to 2160p60
Format HDMI 1.4
HDCP HDCP 1.4
Colour depth 24 bit
Audio formats LPCM, DTS-HD und Dolby TrueHD
Audio outputs digital ./.
analogue ./.
Input connections 1×HDMI
1×RJ45
IR
Output connections 1×HDMI
1×RJ45
IR
Input signal looping ./.
Connection cable in / output module CAT 5e / CAT 6 / CAT 6a / CAT 7
Transmission length CAT 5e / CAT 6 100m up to 1080p @ 60Hz 36bpp
70m 1080p @ 60Hz 48bpp
1080p @ 60Hz 3D
4K×2K @ 60Hz (4:2:0)
Additional equipment Bidirectional transmission of infrared signals
Power supply External power adapter, 100-240V~ 50/60Hz
Operating voltage 12V /1000mA, centre positive
Degree of protection IP20
Dimensions (W×H×D) 113mm×24mm×64mm
Weight Transmitter 79g
Receiver 107g
Ambient conditions Temperature range 0 °C…40°C
Relative humidity 50%, non-condensing
EN
Troubleshooting
Symptom Remedy
No image on the display. Check the status of the control LEDs and ensure that all connections have been
made correctly.
LED 3 ashes, but no image on the display. Check that the correct HDMI input channel is selected on the display.
LEDs 2 are ashing, but LEDs 3 are o. Check that the transmitter is receiving an input signal. Make sure that the HDMI
output of the receiver is correctly connected to the display.
The image on the display is disturbed. Replace the cable at the signal input of the transmitter or use shorter HDMI cables.