Quick start guide

Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [e-mail] DocID: 442579_06.05.2021
Using the product
1. Press the on / o switch (w) to turn on the unit.
2. If the LED ashes red, the built-in battery must be charged. To do this, connect
the device's micro USB charging port (q) to a USB power source using the
supplied charging cable. When the charging process is complete, the LED lights
green. Then disconnect the device from the USB power source.
3. When the LED is ashing green and red, the device is ready to connect to
a Bluetooth® enabled device, such as smart phone, tablet or the like. Then
establish the connection.
4. When connected, the LED is green.
5. Use a suitable cable to connect the XLR output (e) to the input of the device
that you want to use to process the line level signals.
6. Start the media playback on the audio source.
7. To switch o the device, press the on / o switch (w).
EN
For the transport and protective packaging, environmentally friendly materials
have been chosen that can be supplied to normal recycling. Ensure that plastic
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma-
terials with your normal household waste, but make sure that they are collected
for recycling. Please follow the notes and markings on the packaging.
Batteries must not be thrown away or incinerated; they must be disposed of in
accordance with local regulations for the disposal of hazardous waste. Use the
existing collection points for this.
Dispose lithium batteries only in discharged condition. Remove replaceable
lithium batteries from the device before disposal. Protect used lithium batter-
ies from short circuits, for example by covering the poles with adhesive tape.
Permanently installed lithium batteries must be disposed of together with the
device. Please inquire about a suitable acceptance point.
This product is subject to the European Waste Electrical and Electronic Equip-
ment Directive (WEEE) in its currently valid version. Do not dispose of your old
device with your normal household waste. Dispose of this product through an
approved waste disposal rm or through your local waste facility. Comply with
the rules and regulations that apply in your country. If in doubt, consult your
local waste disposal facility.
Bluetooth® Receiver
Technical specications
Standby current <0.5mA
Sensitivity –80dBm <± 0.1%BER
Signal-to-noise ratio ≥75dB
Distortion ≤ 0.1%
Range (free eld) 10m
Battery Type Lithium polymer battery
Voltage 3.7V
Capacity 300mAh
Operating time 10 h
Charging time 1 h
Bluetooth® Frequency of operation 2.400 GHz ... 2.4835 GHz
Max. transmission power 10 mW
Standard Version 4.0
Dimensions (W×H×D) 125mm×32mm ×28mm
Weight 100g
Ambient conditions Temperature range 0 °C ... 40 °C
Relative humidity 20 % ... 80 % (non-condensing)
. . .
or
or