SM WC324 Carrier Manual f5d7c556 8ee3 43e4 98c4 52f053410751

BACK-TO-WALL TOILET INSTALLATION INSTRUCTIONS

— 9 —

Toilet Installation

1. Fit Pipe

· Install pipe and make sure it is thoroughly inserted.

· With a ruler, mark a line on the pipe where it meets the finished wall.

· Remove from wall and install pipe in the back of the toilet and make sure it is thoroughly inserted.

· With a ruler, mark a line on the pipe where it meets the back of the bowl.

2. Cut Pipe

· Measure the distance between both marked lines on pipe. Take measured distance, deduct

from bald end of pipe and cut pipes as shown below. This will allow some tolerance to recut if necessary.

· After cutting, take a file and remove all burrs. Try and bevel pipe edge.

3. Install Toilet

· Insert pipe into bowl first, remember to apply grease where necessary.

· Install pipe into wall, make sure toilet is level.

L + ¹5⁄16”