Installation

— 3 —
3. Ensure Tub is Level
· Place level across the bottom surface of the
apron and the adjustable feet to verify the tub
is level. If it is not, adjust the feet accordingly.
Do this for all adjustable feet.
· Carefully flip tub over into the upright position.
Reverify that the tub is level.
2c. If the hole on the support bar does not line
up with the pre-drilled holes in the apron,
please complete the following steps:
- Using a screwdriver, loosen the screws
holding the hinge in place. Do not remove
the screws completely.
- Once the hinge can move, reposition the
support bar so the holes are aligned.
- Re-tighten the screws for the hinges to re
secure the support bar to the bathtub.
- Use the screw to securely attach the
support bar to the apron.
ALCOVE BATHTUB INSTALLATION INSTRUCTIONS