Use and Care Manual

— 8 —
Toilet Installation
L2
L1
L1 + zɀƔdžȢ”
L2
L2 + zɀƔdžȢ”
L1
1. Fit Pipes
· Install pipes and make sure they are thoroughly inserted.
· With a ruler, mark a line on the pipe where it meets the finished wall.
2. Cut Pipes
· Measure the distance between both marked lines on pipe. Take measured distance, deduct from
bald end of pipe and cut pipes as shown below. This will allow some tolerance to recut if necessary.
· After cutting, take a file and remove all burrs. Try and bevel pipe edge.
L1: The distance between the two lines on the straight tube.
L2: The distance between the two lines on the connecting pipe.
· Remove from wall and install pipes in the back of the toilet and make sure they are thoroughly inserted.
· With a ruler, mark a line on the pipe where it meets the back of the bowl.
WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS