Instructions / Assembly

If you have any questions or concerns please contact us:
1-434-623-4766
[e-mail]
PRIOR TO INSTALLATION:
· Inspect carrier to ensure no damages have occurred while in shipping.
· Observe all plumbing and building codes in accordance with your state and local requirements.
· All dimensions are nominal! Be sure to measure prior to installation.
· The step-by-step guidelines in the installation instructions are a general reference. Should there be
any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss
Madison products by hiring a licensed professional.
· Read installation and maintenance instructions thoroughly before installing. Be sure to use proper
tools and always wear proper personal safety accessories for your protection.
· Additional floor and wall preparations may be necessary to avoid damage to the product.
· Carrier will not fit in a 2x4 wall (2x6 minimum wall).
· An access panel will be needed behind to make all connections. It is not recommended to do this on
an exterior wall.
· All four bolts will need to be loosened to adjust the frame height. Do not take out loosened bolts while
adjusting.
· Separate water shut offs should be installed and accessible.
· A mixing valve may be required per code and will avoid scalding.
· This product is a required component for all Swiss Madison wall-hung bidet installations.
SUGGESTED TOOLS & MATERIALS:
Safety
Glasses
Wrench
Drill
Tape
Measure
Level
— 1 —
WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS
Socket
Wrench
Screwdriver