Installation Guide
SHOWER BASE INSTALLATION INSTRUCTIONS
Leveling the oor
1. Verify that the shower base is level using the “level” tool on all four sides.
• If the shower base is level proceed to step 2.
• If shower base level use shims or mortar compound to adjust accordingly. Verify with “level
tool.”
2. Mark drain hole on oor. (All in oor plumbing must be installed by a certied plumber.)
To ensure base is installed correctly,
entire bottom support must contact
a at, level surface.
Bottom Support
Bottom Support
Wall
Level
Square
Pre-attach Drain
WARNING: DO NOT discard cardboard ring.
1. Remove shower base from dry t.
2. Thread silicone or plumbers putty under drain lip, so when inserted excess sealant will squeeze out
from between drain and shower base oor creating an air tight seal.
3. Flip shower pan upside down: Add rubber ring then cardboard ring and lastly screw on the plastic
ring.
4. While holding the bottom of the shower drain in place with split-joint pliers, use shower wrench to
tighten the plastic ring until drain sits ush with shower base oor.
5. Use rubbing alcohol and a towel to remove all excess silicone/plumbers putty from around drain lip.
3