Installation Guide

2. Connect Pipes
· Install waste and overflow into sink basin.
· Screw plumbing pipes into basin. Plumbing
not included.
· 1 ¹⁄2” Discharge pipe location varies between
models and may need to be re-plumbed
before installation.
4. Seal Sink - 2 People Required
· Dry fit pedestal sink before final installation.
· Person 1- Slightly tilts sink back, so basin just barely
lifts off ground. Person 2- Apply construction adhe-
sive underneath the sink. Then both gently lower
basin back to standing position.
· Caulk the sink to the floor with silicone or sealant.
Do not use sink until 24 hours after sealing.
— 2 —
3. Connecting Plumbing
· We recommend installing faucet (not included)
while back of sink is accessible.
· Align pipes in basin to plumbing in wall.
· Tighten into place, with clockwise motion.
· Water shutoff valve should be slightly above
the 1 ¹⁄2” drain line coming out of the wall.
1. Verify Sink Location
· Using a pencil mark the location where
you want the sink to be onto the floor.
ONE-PIECE PEDESTAL SINK INSTALLATION INSTRUCTIONS
x”
Discharge Pipe