Owners Manual

— 5 —
1. Drill two holes in the required position on the wall
using a 14mm masonry drill bit, to a depth of 75mm.
3. Screw a fixing bolt into each fixing plug using a
8mm spanner until the spanner contacts the wall.
4. Place the basin in position against the wall.
Locating the fixing bolts through the holes in the rear of
the basin. Push a plastic washer followed by a metal
washer, onto each fixing bolt.
5. Screw a metal nut onto each fixing bolt to secure
the basin. Caution: Do not over-tighten, as this may
damage the ceramic.
2. Push a wall plug into each hole.
Plastic Solenoid Metal Screw Plastic Gasket Metal Gasket Metal Nut
NOTE: Drawing may not exactly define contour of china.
2. Install Sink
Use your assembled console to mark on the wall where the bottom of the sink should rest.
Using the steps illustrated below install your sink.
NOTE: Make sure your sink is LEVEL before marking and securing into place.