Full Product Manual

10. Vanity Top Installation
· Install faucet and drain according to manufacturer’s installation instructions. Do not overtighten,
this may cause the sink to crack.
· Set the vanity top on top of the vanity base, checking the location of the p-trap and drain.
· Remove vanity top from vanity base. Apply a thin bead of silicone around the vanity base and set
the vanity top carefully in place.
· Remove excess silicone with a wet cloth.
Wait 24 hours
before use.
24H
!
— 7 —
FREESTANDING VANITY INSTALLATION INSTRUCTIONS
9. Secure Vanity to Wall
• Select installation method from below. Please note that mounting hardware is not supplied with this vanity.
Option 1: Securing to Drywall
· Position cabinet against wall in desired location.
· Using a pencil, make a mark on the wall through
the holes in the rear top bar (7).
· Move cabinet away from the wall. Create a pilot
hole in each mark on the wall, then insert a plastic
anchor.
· Place cabinet against the wall, insert a screw
through the rear top bar (7) into each hole in the
wall, then tighten to plastic anchors to secure the
vanity.
Option 2: Securing to Drywall & Wood Stud
· Position cabinet against wall in desired location,
be sure desired mounting location aligns with
existing wood studs.
· Insert mounting screw through the hole in the rear
top bar (7), then tighten through the drywall into
the wooden stud. Repeat this step for the side to
secure the vanity.