Full Product Manual

3. Assemble Frame

• Use 5 cam locks (B) to attach the left side panel (2) to the front cross bar (4), rear top bar (7) and

rear bottom bar (8).

• Repeat for the right side panel (3).

— 3 —

FREESTANDING VANITY INSTALLATION INSTRUCTIONS

2. Prepare Frame & Side Panels

• Connect a cross beam (11) to the front cross bar (4) via the cam bolt (A) installed in the front cross bar (4).

Secure into place with a cam lock (B). Repeat with the remaining cross beam (11).

• Complete the frame by attaching the rear top bar (7) to the cross beams (11) using 2 screws (E). Secure

into place by tightening the screws (E) using an allen key (D).

• Screw 5 cam bolts(A) into the left panel (2). Repeat for the right side panel (3).

• Insert 2 wooden dowels (C) into the left side panel (2) as shown. Repeat for the right side panel (3).

• Screw 4 screws (G) into the left side panel (2) as shown, being careful to not overtighten. Leave about

2-3 mm of the screw exposed above the panel. Repeat for the right side panel (3).

Do not

overtighten