Product Manual

INSTALLATION OF BUCKET ATTACHMENT

TO ENSURE PROPER INSTALLATION, CARFULLY

FOLLOW ALL INSTRUCTIONS LISTED BELOW

REFER TO FIGURE 1 WHILE INSTALLING THE BUCKET ATTACHMENT

1. BEGIN BY LAYING OUT THE PARTS SIMILAR TO FIGURE 1

2. ATTACH THE BUCKET HITCH(2) TO THE BUCKET(1) USING BOLTS(6) AND NUTS

(7).

3. INSTALL THE LATCH REST BOLT(5), ROLLER BUSHING(3) AND NUT(9) TO THE

BUCKET.

4. PLACE THE BUCKET LATCH(4) IN THE UPRIGHT TABS ON THE BUCKET HITCH(2)

USING BOLT(5) TO HOLD IT THERE.

5. INSERT THE BENT PART OF THE SPRING(14) INTO THE BUCKET LATCH(4) ON

THE SIDE FACING THE CENTER OF THE BUCKET HITCH(2) AND OVER THE BOLT

(5) GOING THROUGH THE LATCH. THE LONG STRAIGHT PART OF THE SPRING

WILL REST ON TOP OF THE BUCKET HITCH(2).

6. NEXT, PLACE THE WASHER(11) OVER BOLT (5) ENDING WITH NUT (9), TIGHTEN

THE ASSEMBLY UNTIL THE NUT IS ALL THE WAY ON THE BOLT, ALLOWING

LATCH (4) TO ROTATE FREELY.

7. PLACE THE ASSEMBLED BUCKET ATTACHMENT IN FRONT OF YOUR ALREADY

INSTALLED SWISHER ACCESSORY MOUNT.

8. INSERT THE PLOW MOUNT PIN(13) THROUGH THE BUCKET HITCH AND THE

ACCESSORY MOUNT.

9. SECURE THE PIN WITH THE CLICK PINS(10) ON EACH END OF THE MOUNT PIN.

10. TIE THE RED TRIP RELEASE ROPE(16) TO THE TOP OF THE BUCKET LATCH(4).

11. ATTACH YOUR WINCH HOOK TO THE TOP OF THE BUCKET HITCH, THROUGH

THE EYELET PROVIDED.

REV. 08-3502738