Use and Care Guide

CAUTION: SHUT OFF THE CUTTER ENGINE AND REMOVE SPARK

PLUG WIRE FROM SPARK PLUG BEFORE MAKING ANY

ADJUSTMENTS TO THE CUTTER.

STARTING THE ENGINE

See engine manufacturer’s recommendations for the type and amount of oil and fuel used.

• Make sure the tow vehicle parking brake is set, mower is level, and blades are

disengaged. Engine must be level to accurately check and fill oil. Do not overfill.

• Check spark plug wire, oil, and fuel.

• Check all electrical connections for buildup of debris.

• Set engine idle to “CHOKE” position.

• Turn key to the “RUN” position, then to the “START” position.

• Set engine idle at maximum RPM for best performance.

• Allow engine to run a few moments before engaging blades.

ENGAGING BLADES

Note: Do not attempt to start the unit with the engage switch console in the “ENGAGED” position.

• Engage blades by pulling out on the PTO switch.

• Push PTO switch in to disengage blades. See detail on page 16 figure – 8

• The braking system is applied when the blades become disengaged. It is designed to bring

the blades to a quick stop (approximately 10 seconds). The electric clutch comes with an

internal brake.