Use and Care Manual
Table Of Contents
- Cover
- Warranty
- Safety Precautions 1
- Safety Precautions 2
- Assembly
- Operation 1
- Operation 2
- Operation 3
- Maintenance
- Troubleshooting
- Safety Decals
- Front Skirt Detail
- Hitch Detail
- Gas Tank Detail
- Blade Driver Detail
- Engine & Clutch Detail
- Idler Detail
- Cover Detail
- Caster & Axle Detail
- Axle Support Detail
- Rear Debris Guard Detail
- Console Detail
- Belt Configuration
- Carbon Cannister Detail
- Repair Parts
- Ordering Information
킐
֮◌
The unit is not cutting level.
• Check for bent or broken blades
• Without the engine running, make certain blades are installed identically.
The engine will not start.
• Disengage blades, turn key switch to the “OFF” position, check battery and
all other electrical connections and inspect spark plug and wire.
• Contact engine manufacturer or qualified mechanic.
Engine runs poorly.
• See engine manual.
• Check the throttle adjuster.
• Replace fuel, clean fuel filter and fuel line.
• Check spark plug and gap.
Cutter bounces excessively while towing.
• Decrease tire pressure.
• Tow at a lower speed.
IF PROBLEMS PERSIST HAVE A QUALIFIED MECHANIC SERVICE
THE CUTTER. NEVER ATTEMPT TO MAKE AN ADJUSTMENT THAT
YOU ARE NOT SURE IS CORRECT. DOING SO CAN CAUSE OTHER
PROBLEMS.
9
GENERAL TROUBLESHOOTING