Use and Care Manual
Table Of Contents
- Cover
- Limited Warranty
- Safety Precautions 1
- Saftey Precautions 2
- Assembly
- Operation 1
- Operation 2
- Operation 3
- Maintenance
- Troubleshooting
- Safety Decals
- Deck Leveling Detail
- Front Skirt Detail
- Hitch Detail
- Motor Base Detail
- Wheel Detail
- Height Adjust Detail
- Deck Detail
- Blade Driver Detail
- Engine Detail
- Idler Detail
- Belt Configuration
- Console Detail
- Wiring Diagram
- Fuel Tank Detail
- Carbon Canister Detail
- Battery Detail
- Battery Cable Assembly
- Hitch Positioning
- Slope Guide
- Ordering Information
11
UNCRATING & SET-UP DIAGRAM
DECK LEVELING DIAGRAM
FIGURE 1
FIGURE 2
FRONT TO BACK ADJUSTMENT
For best cutting results, the cutter deck should be parallel to the ground. To check parallel
adjustment, measure the distance from the bottom edge of the deck in both the front and rear of the
deck. This adjustment is best done while the tow vehicle and Trail Cutter are connected.
Item #
Description
Part #
12
Washer - 3/4 ID 18 GA
NB179
13
Coupler - 2" Ball
7365
14
Bolt - Hex, 3/8-16 X 3"
NB150
15
Washer - 3/8 SAE Flat
NB272
Item #
Description
Part #
1 Weldment - Hitch Mount; RC44 21114*
2
Nut - 3/8-16 Lock
NB182
3
Nut - 3/4-10 Lock
21132
4
Washer - 3/4" SAE Flat
NB146
5
Nut - 5/8-11 Lock
21138
6
Pin - Clevis 3/8 X 3 ZP
21131
7
Bolt - Hex, 5/8-11 X 2 1/2"
NB667
8
Top Link - Cat 0 W/ Adjusting Rod
21103
9
Bolt - Hex, 3/4-10 X 4 1/2"
21130
10
Pin - #39 Hair Pin (A155H)
NB127
11
Bolt - Hex, 3/8-16 X 1 1/4
NB618