Use and Care Manual

ﵪﵪ
̤
GENERAL RECOMMENDATIONS
• Set the Cutter to an appropriate height for the media being cut.
Taller/Thicker grass & brush may require a higher first cut and
a lower second cut for best results. It’s recommended to cut the
second pass perpendicular to the first pass.
• Height indicator decal contains number references. These
numbers do not reflect cutting height or inches. They are only a
quick reference to note where the height is set on each side of
the unit.
ADJUSTING HEIGHT
• Attach unit to the tow vehicle.
• Find the Crank Handle 1 located on either side of the Cutter.
Figure 17.1
• To raise deck - Rotate Handle 1 clockwise. Figure 17.2
• To lower deck – Rotate Handle 1 counter-clockwise. Figure
17.2
• Lock handle at chosen height by pivoting the handle and
placing it into the notch located at either end of the Height
Adjustment Housing 4 . Figure 17.3
• Take note of the Bolt 2 location on the Height indicator Decal
3 .
• Repeat steps on opposite side of the Cutter. Ensure Bolt is in the
same location on the Height Indicator Decal on both sides. This
will help provide a level cut.
HEIGHT ADJUSTMENT MAINTENANCE
• Apply multipurpose grease/oil to Height Adjustment Threaded
Rod regularly.
• Ensure all hardware is tight and in place before each use.
• Check tires for low pressure, punctures, or wear.
17
FIGURE 17.1
FIGURE 17.2
Unlocked Crank Handle
FIGURE 17.3
Locked Crank Handle
See Page 22 for
replacement part numbers
HEIGHT ADJUSTMENT