Use and Care Manual

罆
̚
When ordering replacement parts
* = USE PAINT CODE: TK=BLACK
16
Engine shield not shown for Clarity
FIGURE 16.1
Cutter requires a U1 Battery (not included).
BATTERY WIRING
* ALWAYS CONNECT POSITIVE CABLE FIRST WHEN CONNECTING BATTERY
* ALWAYS REMOVE NEGATIVE CABLE FIRST WHEN DISCONNECTING BATTERY
(See FIGURE 16.1)
• Locate (+) Red Cable 4 coming from Solenoid. Attach Red Cable 4 to the (+) positive terminal on
Battery and fasten with provided ¼-20 Nut and Bolt 1 2 using 7/16” wrenches.
• Locate (-) Black Cable 3 and using ¼-20 Nut and Bolt 1 2 attach it the (-) Battery terminal.
• Replace Cover and fasten with three Thumbscrews previously removed. (See Page 15)
• For removal of Battery, follow steps in reverse order.
BATTERY MAINTENANCE
• The Battery can be accessed without tools by removing the Thumbscrews holding on the front Cover.
• Keep Battery charged for best performance. Run unit for at least 45 minutes at a time to properly
charge the Battery during use.
• Clean any corrosion build-up from terminal.
• Check terminal bolts for looseness. Tighten if needed.
NOTE: The positive and negative terminals may be in a different
location on your Battery than what is shown. Image is for reference only.
Wrench/Socket
Qty. Size
(2) 7/16”
Tools Required:
See Page 24 for replacement part numbers
BATTERY CABLES