Use and Care Manual
Table Of Contents
- Cover
- Limited Warranty
- Table of Contents
- Safety Precautions
- Features
- General Operations 1
- General Operations 2
- General Operations 3
- Maintenance
- Troubleshooting
- Specifications
- Safety & Operation Decals
- Assembly Parts
- Set-Up Directions
- Battery
- Battery Cables
- Height Adjustment
- Hitch Operations 1
- Hitch Operations 2
- Blade Replacement
- Belt Removal & Installation
- Height Adjustment Assembly
- Front Skirt Assembly
- Covers Assembly
- Engine Guard Assembly
- Gas Tank Assembly
- Solenoid Assembly
- Deck Assembly
- Hitch Assembly
- Blade Driver Assembly
- Engine Pulley & Belt Assembly
- Idler Configuration
- Console Assembly
- Wiring Diagram
- California Emissions Requirements
- Torque Specifications Reference Guide
- Slope Guide
- Ordering Information
When ordering replacement parts
* = USE PAINT CODE: TK=BLACK
16
Engine shield not shown for Clarity
FIGURE 16.1
Cutter requires a U1 Battery (not included).
BATTERY WIRING
* ALWAYS CONNECT POSITIVE CABLE FIRST WHEN CONNECTING BATTERY
* ALWAYS REMOVE NEGATIVE CABLE FIRST WHEN DISCONNECTING BATTERY
(See FIGURE 16.1)
• Locate (+) Red Cable 4 coming from Solenoid. Attach Red Cable 4 to the (+) positive terminal on
Battery and fasten with provided ¼-20 Nut and Bolt 1 2 using 7/16” wrenches.
• Locate (-) Black Cable 3 and using ¼-20 Nut and Bolt 1 2 attach it the (-) Battery terminal.
• Replace Cover and fasten with three Thumbscrews previously removed. (See Page 15)
• For removal of Battery, follow steps in reverse order.
BATTERY MAINTENANCE
• The Battery can be accessed without tools by removing the Thumbscrews holding on the front Cover.
• Keep Battery charged for best performance. Run unit for at least 45 minutes at a time to properly
charge the Battery during use.
• Clean any corrosion build-up from terminal.
• Check terminal bolts for looseness. Tighten if needed.
NOTE: The positive and negative terminals may be in a different location
on your Battery than what is shown. Image is for reference only.
Wrench/Socket
Qty. Size
(2) 7/16”
Tools Required:
See Page 24 for replacement part numbers
BATTERY CABLES