Use and Care Manual

6
Pivot Mount Assembly
1. Connect Skid Weldment 10068 (17) through the channel on the outer right edge of the Blade
using Clevis Pin NB300 (12) and Hair Pin NB127 (15) in the order shown below. Repeat for
the left side. The height can be adjusted using the holes in the Skid Weldment leg.
2. Assemble the Pivot Mount assembly to the Blade using ½-13 X 2 Bolt NB509 (18), ½
Washer NB177 (19) and ½-13 Nyloc Nut NB281 (20) in the order shown below. It is
important to ensure the ½ Washer (19) is installed between the Blade and Pivot Mount
assembly to allow for the correct rotation of the pivot. Repeat for the other side of the Pivot
Mount. Do not overtighten; the Blade should be able to pivot freely after being assembled to
the Pivot Mount.
3. Assemble the Tilt Block (21) to the left side of the Pivot Mount assembly using ½-13 X 2 Bolt
NB509 (18), two NB177 ½ Washers (19) and ½-13 Nyloc Nut NB281 (20). Repeat for the
right side of the Pivot Mount assembly. The Tilt Blocks (21) set the vertical “tilt” or rake of
the Blade.
TO ENSURE PROPER ASSEMBLY, CAREFULLY
FOLLOW ALL INSTRUCTIONS LISTED BELOW
The numbers in parenthesis
on this page refer to items
from the table on page 4.