Use and Care Guide

INSTALLATION INSTRUCTIONS:

• Using two 1/2” box end wrenches, remove the original brush guard (10681TK) from your existing Walk

Behind unit. It is held in place with six nuts (NB170) and six bolts (NB596). In order to assemble your

caster kit to your unit, you will need to remove a total of ten nuts (NB170) and ten bolts (NB596) as

shown in Figure 2.

Item # Part # Description Qty

1 NB170 Nut - Serrated Flange 5/16-18 10

2 10681TK Guard - Brush, Txt Blk 1

3 NB596 Bolt - Serrated Flange, 5/16-18 X 3/4 10

Model WBRC11524 is shown.

Note: Items called out on this page

are components of your existing

unit. Replacement hardware is

provided with this kit and can be

found in the hardware bag.

Figure 2

Disassembling Your Brush Guard