Use and Care Guide

Before assembling your Caster Kit, please check the table and diagram below to

familiarize yourself with the parts and to make sure no parts are missing.

Parts List

Note: Items labeled with * are

located in the hardware bag.

Item # Part # Description Qty

1* 094618 Cap 2

2* NB122 Nut - Jam, Nyloc 3/4-16 2

3* 17X195 Washer - Flat 2

4* NB195 Washer - 13/16 X 1 1/4 X 1/8 4

5 B98 Bearing 4

6 19631TK Weldment - Brush Guard Housing, Txt Blk 1

7 19638TK Weldment - Caster, Txt Blk 2

8 19642 Bolt - 5/8-11 X 5 2

9 NB149 Washer - 5/8 ID X 1 OD 14 GA 4

10 19641 Tire/Wheel - 8 X 3 2

11 NB595 Nut - Lock Jam, 5/8-11 2 Way 2

12* NB596 Bolt - Serrated Flange, 5/16-18 X 3/4 10

13* NB170 Nut - Serrated Flange 5/16-18 10

Figure 1

INSTALLATION INSTRUCTIONS

• Assemble the casters to the brush guard using the hardware from the hardware bag in the order shown

in Figure 1. Using a 1-1/16” wrench, tighten item number 2 (NB122) enough to engage the nyloc portion

of the nut while still allowing the caster to rotate freely. Item numbers 12 (NB596) and 13 (NB170) will

be installed in a later step.

Tools Required:

One 1-1/16” Wrench

Two 1/2” Box End Wrenches

Tip: Valve stems should be turned

to avoid contact with caster yoke.