User's Manual

//SPI_Write_Buf(WRITE_REG+RX_ADDR_P0,TX_ADDRESS,TX_ADR_WIDTH); // RX_Addr0 same as

TX_Adr for Auto.Ack

SPI_Write_Buf(WR_TX_PLOAD, tx_buf, TX_PLOAD_WIDTH); // Writes data to TX payload

SPI_RW_Reg(WRITE_REG + CONFIG, 0x0e);

// Set PWR_UP bit, enable CRC(2 bytes) & Prim:TX. MAX_RT & TX_DS enabled.. CE=1;

dalay10us(); CE=0; }

void nRF24L01_Config(void) {

//initial io CE=0; // chip enable CSN=1; // Spi disable

SCK=0; // Spi clock line init high CE=0;

SPI_RW_Reg(WRITE_REG + CONFIG, 0x0f);

// Set PWR_UP bit, enable CRC(2 bytes) & Prim:RX. RX_DR enabled..

SPI_RW_Reg(WRITE_REG + EN_AA, 0x01);

SPI_RW_Reg(WRITE_REG + EN_RXADDR, 0x01); // Enable Pipe0

SPI_RW_Reg(WRITE_REG + SETUP_AW, 0x02); // Setup address width=5 bytes

SPI_RW_Reg(WRITE_REG + SETUP_RETR, 0x1a); // 500us + 86us, 10 retrans...

SPI_RW_Reg(WRITE_REG + RF_CH, 0);

SPI_RW_Reg(WRITE_REG + RF_SETUP, 0x07); // TX_PWR:0dBm, Datarate:1Mbps, LNA:HCURR

SPI_RW_Reg(WRITE_REG+RX_PW_P0, RX_PLOAD_WIDTH);

SPI_Write_Buf(WRITE_REG + TX_ADDR, TX_ADDRESS, TX_ADR_WIDTH); SPI_Write_Buf(WRITE_

REG + RX_ADDR_P0, TX_ADDRESS, TX_ADR_WIDTH); CE=1; //

}

Limited Modular Approval

This RF Module is strictly limited to integration into three battery powered host devices. These

host information as below:

Manufacture: SwipeSense, Inc

Products: Wearable Dispenser (model: 2003.0),

Wall Sensor (model: 4004.0),

Badges (model: BAD001).

Integration into devices that are directly or indirectly connected to AC lines must add with Class II

Permissive Change. (OEM) Integrator has to assure compliance of the entire end product incl. the

integrated RF Module. Additional measurements (15B) and/or equipment authorizations (e.g

Verification) may need to be addressed depending on co-location or simultaneous transmission

issues if applicable. Integrator is reminded to assure that these installation instructions will not

be made available to the end user of the final host device.

With the documented max output power this RF Module meets the FCC SAR Exemption, so it

comply with any applicable RF exposure requirements in its final configuration. The RF Module is

device, into which this RF Module is integrated" has to be labeled with an auxiliary label stating

the FCC ID of the RF Module, such as “Contain FCC ID: 2AB5RMOD001"."