User Manual

If the paper shredder will not start, please check the following:
1. Is the machine plugged in correctly?
2. Is the switch pushed to the ‘ON/AUTO’ position?
3. Is the machine jammed with paper?
4. Has the motor overheated?
5. Is the shredder bin fully pushed in?
In case of jammed paper, please follow the procedure below:
1. Check if the bin is too full with paper - the bin should be emptied regu-
larly to avoid paper becoming jammed in the cutters.
2. Slide the switch to the ‘REV’
( ) position to reverse the jammed paper.
3. If the paper is so jammed that it will not come out in reverse function,
slowly push the switch between ‘REV’
( ) and ON/AUTO. Do not do
this too quickly as this can damage the shredder.
4. WARNING – Do not under any circumstances use any metal objects (scis-
sors, letter openers etc.) in an attempt to clear the entry – this model has
mains voltage inside the casing, which could cause serious injury.
This machine does not require lubricant. ACCO Brands accepts no liability for
product performance or safety should any lubricant be used on any part(s)
of this machine.
CAUTION:
Do not shred continuously for more than 3 minutes. When the motor has
overheated, the thermal safety switch will start working automatically. If the
thermal switch trips, do not use the machine for about 30 minutes while the
thermal sensitive safety switch cools down so the shredder can be safely
used again.
CAUTION:
• Thismachineisnotatoy.Keepawayfromchildrenandpets.
• Forindooruseonly.
• Neverinsertfingersintotheentryslotoftheshredder.
• Turnthepoweroffimmediatelyifyourhair,tieorsleevebecomes
entangled in the shredder.
• Theshredderbinmustbefullypushedclosedforthemachineto
operate.
• Emptytheshredderbinwhenitisfullotherwisetheshredder’sperfor-
mance will be adversely affected. Operating the shredder with
a full shredder bin can result in paper jamming in the cutters, which
will increase the machine’s noise level.
• Donotforcedownshredderpaperinthebinusingyourfeet.
Emptying the pull-out waste bin (fig 4)
Empty the shredder bin when the shredder paper is visible through the viewing
window on the side of the pullout bin.
1. Pull out the shredder bin (fully).
2. Empty the shredder bin into a waste sack.
3. Push the shredder bin back in ensuring it is fully closed.
Register this product online at www.swingline.com
6
Technical data
Model Swingline
™
Style+
™
Cutting Type Cross Cut
Shred Size 4 x 23mm
Sheet Capacity @ 80 gsm paper 7 sheets
Sheet Capacity @ 75 gsm paper* 7 sheets
Entry Width 230mm
Product Dimensions 378 x 203 x 360mm
Rated Voltage/Frequency 120Vac~60Hz
Rated Current 3.0 A
* 8.5” x 11”, 20lb., (75g) paper at 120V, 60Hz, 3 Amps; heavier paper,
humidity or other than rated voltage my reduce capacity.