Installation Guide

Assembly Instructions
9
  
  
ELBOW AND EXIT SECTION ASSEMBLY
1. Assemble the Elbow Section by securing as shown in
(Fig. 2) and (Fig. 2a). Join sections using a hex head
bolt, two flat washers and a loc nut at each hole junction.
NOTE: Fasten each loc nut finger tight. Each time you
join parts be sure each flanged lip is mating with a flat lip.
3. Assemble and secure the Exit Section as shown in
(Fig. 2a) and (Fig. 2b).
2. Repeat step 1 to assemble (3) remaining Elbow Sections.
4. Tighten all hardware.
NOTE: Interlocking design of flanges on Elbow pieces
will assist in assembly.
Fig. 2
Fig. 2a
Fig. 2b
FLANGE DETAIL
x4
Elbow Section - 9 bolts each
Exit Section - 9 bolts
7/8" Hex Head Bolt
Washer
Washer
Loc Nut
Flange
Opening