Installation Guide

Assembly Instructions

Fig. 1

Entrance Section Assembly

NOTES:

• At least two individuals are needed to assemble the 5' Turbo Tube Slide.

• To aid in aligning holes when assembling sections, insert a screwdriver through adjacent holes

to maintain hole alignment.

1. Assemble the Entrance Section by securing the top seam first, as shown in (Fig. 1). Join sections

using a 7/8" hex head bolt, two flat washers, and a loc nut at each hole junction.

2. When securing the bottom seam make certain to attach the Backing Plate to the left side of the

seam as shown in (Fig. 1) securing in place as shown using 1" bolts.

3. Tighten all hardware.

1" Hex Head Bolt

7/8" Hex Head Bolts

on top seam

1" Hex Head Bolts

through Backing Plate

Washer

Loc Nut

Backing Plate