Installation Guide

Assembly Instructions
14
NOTE:
This plan uses a generic tower to
illustrate the 5' Turbo Tube Slide being
attached. However, this same procedure
is to be used for any Swing-N-Slide
5’ Tower Playset.
5' DECK HEIGHT
(3)
2-1/2” screws
per joint
23"
(58,4 cm)
(4)
2-1/2”
screws
per barrier
board
3-1/4'' Gap
Between Each
Barrier Board
2” x 4”
Cut To Width of Your Unit
2” x 4”
Cut To Width of Your Unit
2'' x 4''
Barrier Board
Cut to Height
of Rail
Slide Barrier Construction
1. Carefully remove your Barrier Support Boards from the barrier
where you would like to place your slide, making certain you will
have a clear 72'' Safety Zone for your slide (Fig. 6).
Retain this lumber and fasteners as you will need them
in a later step.
2. Cut to length and install (2) 2'' x 4'' Barrier Support Boards
as shown in (Fig. 6a), making certain the opening
between them is 24-1/4''.
3. Cut (1) 2'' x 4'' Barrier Board to the height of your barrier
railing and create a slide opening of 23'', as shown in (Fig. 6a).
4. Reattach your barrier boards, making certainthey are evenly
spaced and do not have a gaplarger than 3'' between each board,
as shown in (Fig. 6a).
2-1/2'' screw
24-1/4"
(61,6 cm)
59-1/4"
(150,5 cm)