Installation & Assembly

Step 3: Strap the lap belt around your child’s waist and securely

snap the buckle in place. The fit of the belt should be

snug, but not overly tight or constricting.

Note: The Lap Belt is always to be used when a child is

in the Swing Seat.

Step 2: Swing the T-Bar assembly open, away from the seat. With the T-Bar

in its fully open position you should have plenty of room to

comfortably place your child in the Swing Seat.

Step 1: With your fingers, reach behind arm rests on each side of

seat and depress tabs allowing the T-Bar to pop-up away

from seat.

NE 5030L

TB 1539

OTE: When hanging accessory next to other components, a minimum

clearance of at least 8" from adjacent swinging elements or any play equipment support structure is

equired. Additional safety requirements including use zones apply. Consult your assembly instructions for

our particular Swing•N•Slide model.

afety First:

• Installation of proper shock absorbing material is required. Consult the owners manual of your original

wing•N•Slide kit for depth requirements.

• Never leave occupant unattended in child seat.

•

Always secure child with seat belt.

•

Check moving parts and rope for wear at one month intervals.

• Do not allow children to play on equipment when it is wet.

•

On-site adult supervision must be provided at all times.

• This is not a complete list of safety information. Consult the plan and guide of your original

wing•N•Slide kit for a complete list of safety instructions.

aintenance:

• Occasionally check to make sure water drainage holes remain unplugged. Clean them if necessary.

• Do not allow debris or loose materials to accumulate in seat.

•

Periodically inspect cushions for wear, replace if torn or damaged.

Toddler Comfort Swing

Step 4:

Swing the T-Bar shut, inserting the tabs into the slots on both

arm rests. Push down on T-Bar until the tabs lock in place.

This will provide your child with added security and a soft,

comfortable place to grip.

Note: DO NOT

operate the child seat without the T-Bar

locked securely in place.

PAGE 1
NE 5030L TB 1539 Toddler Comfort Swing NOTE: When hanging accessory next to other components, a minimum clearance of at least 8" from adjacent swinging elements or any play equipment support structure is required. Additional safety requirements including use zones apply. Consult your assembly instructions for your particular Swing•N•Slide model. Safety First: • Installation of proper shock absorbing material is required. Consult the owners manual of your original Swing•N•Slide kit for depth requirements.
PAGE 2
Toddler Comfort Swing NE 5030L TB 1539 NOTA: Al colgar el accesorio cerca de otros componentes, deberá separarlo al menos 8'' de elementos moviles adyacentes o cualquier estructura de apoyo de equipos de juegos. Existen otros requisitos de seguridad, incluidas las zonas de uso. Lee las instrucciones de ensamblaje de tu modelo Swing•N•Slide específico. Primero la seguridad: • Es necesario instalar un material apropiado para amortiguar los golpes.