Installation Guide

54
STEP 41
1” Truss Screw (x6)
Grade
2”
59’’
12’’
2-1/2” Deck Screw (x8)
(4)
2-1/2’’ Screws
per board
(4)
2-1/2’’ Screws
per board
30-1/2’’
PF 6009
1-3/8’’x3-3/8’’x17-1/4’’
Slide Stake
(2) 1-1/4’’ Deck
Screws
(4) 1’’ Truss
Screws
(1)
1’’ Truss Head
Screw
per side
Attach brace here
Hex Head Bolt
5/16’’ Washer
5/16’’Loc-Nut
5/16’’ Washer
1. Assemble the slide support using two (2) 2-1/2’’ Deck Screws at each joint, as shown.
2. Assemble the slide halves with a bolt, 2 washers and loc nut at each hole as shown.
3. Line up slide 90° to the platform 2-1/2” from the edge of the deck and secure slide in place using (3) 1’’ Truss Head Screws as shown.
4. After the slide is attached to the platform, attach the slide support to the bottom half of the slide using (1) 1’’ Truss Head screw per side as shown.
Square the support to the ground and bury the ends of the brace. NOTE: The bottom cross support should rest firmly on the ground.
5. Prepare a level area of ground where the bottom of the slide rests 2” below grade.
6. Mark where the slide’s bottom center meets the ground and drive a 1-3/8” x 3-3/8” x 17-1/4” stake until its top is flush to the grade prepared in Step 5.
7. Using a 1/8” drill bit, drill a pilot hole through the bottom lip of the slide and into the stake, and attach using (1) 1’’ Truss Head screw as shown.
NOTE: Be careful to drill into the center of the stake’s end. Level grade around the base making sure the screw head is buried and presents no hazard.
1-1/4” Deck Screw (x2)
(2) [PF 6012] 1-1/2’’ x 3-1/2’’ x 15’’
(2) [PF 6014] 1-1/2’’ x 3-1/2’’ x 36’’
12’’