Instructions / Assembly

25
SWING BEAM How to install Torque Washers
Thread Carriage Bolt
through Torque Washer
before seating the
Torque Washer. Tap
with hammer.
Complete À nal seating
of Torque Washer by
tapping into place.
Make sure Carriage Bolt
square shank is aligned
with square hole in Torque
Washer before À nal seating
of the Torque Washer.
Carriage Bolt
Align shank with washer hole.
Torque Washer
FORT TENT VERTICAL SUPPORTS
RIGHT SIDE
LEFT SIDE
x1
2 x 4 x 69-1/2"
2546-ST
T-Nut
A
A
B
B
2-1/2" Hex Bolt
Lock Washer
Lock Washer
Flat
Washer
Flat
Washer
2" Hex Bolt
1. Pre drill 3/16" pilot holes
through 2546-ST from inside
(A). Center drill in counterbore.
2. Drill 7/16" through holes
through 2546-ST from
outside (B).