Instructions / Assembly
1
Specications subject to change without notice.
Manufactured for Swing-N-Slide® • 1212 Barberry Drive • Janesville, Wisconsin 53545 • USA • 1-800-888-1232 • www.swing-n-slide.com
Made in USA • Printed in USA
LDR 11-29-2017 LA 9408
Slide Mounting Instructions
WARNING: Assembly by adult.
AVERTISSEMENT: L’assemblage dolt être exécuté par un adulte.
ADVERTENCIA: El ensamblaje lo debe hacer un adulto.
WARNING: ASSEMBLY BY ADULT.
ASSEMBLY STEPS
1. Consult (Fig. 1) for proper placement of slide on your unit. Make certain no objects lie within the grayed out area, or ‘Use Zone.’ Position slide to determine
proper location for stake. IMPORTANT: Place the slide on level ground, not less than six feet from any structure or obstruction such as a fence, garage, house,
overhanging branch, laundry line or electric wire. Protective surfacing must extend a minimum of 6ft. in all directions from the perimeter of the equipment or from
the outermost edges of any component. A slide extending beyond the platform must have protective surfacing at least 6ft. out from both sides as well as the
end. An area of 21” on either side of the slide should be free of obstructions which a child’s arm could contact.
2. Drive wood stake (not included) into ground leaving 2” exposed. (Fig. 2)
3. Using an 1/8” drill bit, drill (2) holes through the side of the slide and into stake. Secure the slide bottom to the stake using (2) 1-1/4” deck screws (Fig. 2).
4. Attach slide to unit as shown in (Fig. 3).
Stake
2” x 4” x 17”
Use Pressure-Treated Wood
Not Included In Kit:
For 48” and 60” Deck Heights
Tools Required:
Assembly:
Fig. 2
Fig. 1
48
.
(Fig. 44a) .
.
Fig. 44b
Fig. 3
Instructions below apply to the following models: NE 3051, NE 3052, NE 3053, NE 3054, NE 3060, NE 3061, NE 3062,
NE 4675-12PK, NE 4675-12T, NE 4675-1PK, NE 4675-1T, NE 4675-3PK, NE 4675-3T, NE 4675L, NE 4675LY, NE 4720, NE 4720-1T,
NE 4720-1Y, NE 4720-3Y, NE 4720L, PF 2715, PF 2920, PF 2930, PF 2945, SP 2600, SP 2610, SP 2620, SP 2660, SP 2670, SP 2680,
SP 3029, SP 3079, SP 3088, SP 3099, SP 3100, SP 3200, SP 3300, SP 3500, WS 8200, WS 8201, WS 8202, WS 8334, WS 8335,
WS 8336, WS 8337
Weight Limit: 250 lbs For children 3-10 years of age
1-3/4”
17”
Cut
1-3/4”
(2) 1-1/4” screws
Pre-drill holes with 1/8” drill bit rst
Pre-drill dimple holes through slide with 1/4” drill bit rst
(2) 1-1/4” screws
(Recommend stainless steel or galvanized)
72”
USE ZONE
21”
21”
2” above ground
1-3/4”
Minimum
1-3/4” Minimum
Circular Saw
Electric Drill
Tape Measure
Hammer
1/8” & 1/4” Drill Bits
Phillips Bit
1-1/4” Truss Screws (Included)
(3 or 4 depending on model)
Stake
2” x 4 ” x 17 ”
Use Pressure-Treated Wood