Instructions / Assembly

ManualsBrandsSwing-N-Slide Playsets ManualsPlayground SetsHeavy Duty Swing Hangers (2-Pack)

17-1/2" to 20"

between centers

THE SIZE AND LENGTH OF THE WOOD BEAM DETERMINES THE SWING SET WEIGHT CAPACITY, NOT THE SWING

*FOR CHILDREN AGES 3-11*

SWING HANGERS ARE INTENDED TO HANG SWINGS ONLY. ANY USE OTHER THAN HANGING A SWING IS

HANGERS.

PROHIBITED AND IS NOT RECOMMENDED OR ENDORSED BY THE SELLER.

DO NOT HANG LOOSE ROPES, LOOSE CHAINS, LOOSE PET LEASHES, ETC. FROM THE SWING HANGERS. THE

Iron Swing Hangers (29-6602)

*FOR RESIDENTIAL USE ONLY*

!WARNING!

MAXIMUM WEIGHT CAPACITY OF IRON SWING HANGER PAIR IS 250LBS.

HARDWARE

NOT

INCLUDED

1. Read this page and the following page before beginning.

You must lay out the swing positions along your wood beam accounting for:

A) Spacing between the Swing Hanger centers (17-1/2" to 20")

B) Spacing between the swings (8" minimum)

C) Spacing between the swings and the swing support structure. (8" minimum for swing belts.

Spacing greater than 8" is recommended.)

2. Place the Swing Hanger on top of a 4 x 6 or larger wood beam. The wood beam should be

secured on each end to a supporting structure. The wood beam should be of sufficient

capacity to support the maximum weight allowable by the swing manufacturer(s).

3. Mark through the holes in the Swing Hanger onto the top of the 4 x 6 or larger wood beam.

4. Drill 3/8" diameter holes through the wood beam at the marks.

5. Fasten the Swing Hanger to the wood beam with 3/8" carriage bolts, torque washers, 3/8"

washers and 3/8" lock nuts. Place bolt covers over any exposed threads on the ends of the

carriage bolts. The length of the carriage bolts depends upon the height of the wood beam,

adjust it accordingly. (HARDWARE NOT INCLUDED)

and mark for holes.

centered on top of beam

Place Swing Hanger

Example:

4 x 6 Beam

5 1/2"

3 1/2"

if using 1/2" Flat Washers.)

3/8" x 7"

(Carriage Bolt

Swing Hanger

Carriage Bolt

3/8" Washer

is longer if Beam

3/8" Lock Nut

is larger than 4 x 6)

3/8" x 6-1/2"

Torque Washer

or 1/2" Flat Washer

(Use locking pliers

on head of carriage bolt

Bolt Cover

Summary of content (2 pages)

PAGE 1
Iron Swing Hangers (29-6602) 1. Read this page and the following page before beginning. You must lay out the swing positions along your wood beam accounting for: A) Spacing between the Swing Hanger centers (17-1/2" to 20") B) Spacing between the swings (8" minimum) C) Spacing between the swings and the swing support structure. (8" minimum for swing belts. Spacing greater than 8" is recommended.) 2. Place the Swing Hanger on top of a 4 x 6 or larger wood beam.
PAGE 2
SAFETY TIPS FOR SWINGS  On-site adult supervision is required.  Teach children not to walk close to, in front of, behind, or between moving swings or other moving playground equipment.  Teach children to sit in and never stand on swings. (Exception to this rule is a product called "Stand -N- Swing")  Teach children not to twist the chains and ropes and not to loop them over the swing beam, since this may reduce the strength of the chain or rope.