Instructions / Assembly
9
Assembly Instructions
Washer
Washer
Loc Nut
75/
75
750
Elbow Support
Bracket
Exit Section - 9 bolts
Elbow Section - 9 bolts each
F
ELBOW AND EXIT SECTION ASSEMBLY
1. Assemble the Elbow Section by securing as shown in
(Fig. 2) and (Fig. 2a). Join sections using a hex head
bolt, two flat washers, and a loc nut at each hole
junction.
NOTE: Fasten each loc nut finger tight. Each time you
join parts be sure each flanged lip is mating with a flat
lip.
2. Repeat step 1 to assemble (3) remaining Elbow Sections.
3. Assemble and secure the Exit Section as shown in
(Fig. 2a) and (Fig. 2b). Make certain to attach the
Elbow Support Bracket to the bottom of the flange,
as shown in (Fig. 2b).
4. Tighten all hardware.
NOTE: Interlocking design of flanges on Elbow pieces
will assist in assembly.
!#)!
:/<53$>3<7<5
Hex Head Bolt