Instructions / Assembly
17
Assembly Instructions
*'
2" x 4" x 8-1/4"
2" x 4" x 11-1/4''
2" x 4" x 18"
2" x 4" x 18"
2-1/2" Screws
2-1/2" Screws
2" x 4" x 8-1/4"
(2) 2" Lag Screws
Support Bracket
75
75/
750
SUPPORT AND BRACKET
ASSEMBLY
1. Assemble the support base as shown in (Fig. 10).
2. Attach the support bracket to the support base using
two lag bolts (Fig. 10a).
NOTE: Pre-drill 1/8" pilot holes.
3. Place the support beneath the Exit and determine its
final position. NOTE: Slide support should fit tightly
beneath the slide to assure proper support. Remove
corresponding nut and bolt, attach support to the slide
as indicated in (Fig. 10b). Re-attach hardware.
4. Level grade at the bottom of the slide.
%@3@7::
Loc Nut
Washer
Hex Head
Bolt
FLUSH