Instructions / Assembly
16
Assembly Instructions
1-1/4'' lag screws
2'' lag screws
Slide Installation
1. Lift and attach 5’ Turbo to units, as shown in
(Fig. 9).
Note: Two people will be required to properly
align the Turbo Tube Slide with your tower.
2. On either side of the Slide Entrance there is a
dimple. Insert (1) 2'' Screw in either side, so
that the screw goes into the support board
behind, as shown in (Fig. 9a).
3. Secure Elbow Bracket to 2'’ x 4'' as shown in
(Fig. 9b).
Note: The lower edge of the Elbow Bracket
must sit tightly against the top of the 2'' x 4''
support board.
' )($*!))
#()F
75
*#' +,
!*(
!*(
750
Approximate
1-1/4''
G
ap
2'' x 4''
2'' screw
per side
75/
2'' lag screws
5/16'' Flat
Washers