Instructions / Assembly

8
Assembly Instructions
-+
-+
-+
Entrance Section - 14 bolts
flanged lip
flat lip
t
Exit Section - 13 bolts
90˚ Section (2 are required) - 13 bolts each
loc nut
washer
washer
3/4" bolt
! !: !
#! !
! 
At least two individuals are needed to
assemble the Turbo Tube Slide.
To aid in aligning holes when assembling
sections, insert a screwdriver through adjacent
holes to maintain hole alignment.
 Identify each slide section as either (1), (2),
(3), (4), (5), or (6) as marked on the lip of each
piece.
 Assemble entrance section using pieces (1) &
(2), two 90° sections using pieces (3) & (4),
and the exit section using pieces (3) & (5).
Join sections using a 3/4" hex head bolt, two
flat washers, and a loc nut at each hole
junction (Fig. 1, 2 & 3). ! Fasten each
loc nut finger tight until the entire slide is
assembled. Each time you join parts be sure
each flanged lip is mating with a flat lip.